As part of a remodeling project, I installed a brand new stainless
steel sink a few weeks ago. The model number is Kohler K-3145,
Cadence, Self-Rimming Kitchen Sink.
http://www.us.kohler.com/online...
planning to get good contractor. find the best offer i can have. try
companies offering quality for less. such as Roofing Company including
services like Windows Replacement,and Residential Paintin...
planning to get good contractor. find the best offer i can have. try
companies offering quality for less. such as Roofing Company including
services like Windows Replacement,and Residential Paintin...
planning to get good contractor. find the best offer i can have. try
companies offering quality for less. such as Roofing Company including
services like Windows Replacement,and Residential Painting....
I need to get a leach field replaced. The old one was put over caliche, and
not dug very deep. It was made with minimal amounts of gravel, no more than
12" around the pipes. When checked with a...
Interesting approach to making the numbers work even better!
http://fuelcellsworks.com/news/2010/03/10/fuel-cell-project-weston-reaches-agreement-with-clp/
Man will never fly!
...
Hi guys. My wife and I are in the late planning stages of building
our new home. I want it to be as energy efficient as possible. We
are having a slight disagreement.
I want foam insualtion in...
Sam Takoy - 2010-03-08 15:16:00 [In: Contracting | ]
Hi,
My contractor mentioned to me (but couldn't remember the brand) that
there exist hot water radiators that go between the joists on the floor
below and release heat through an opening in the...
To everyone who helped me with tips on crown molding my special thanks.
A friend helped me Saturday and Sunday. It was a big project, but the
outcome could not have been better. Today I fin...
Several people have asked to see a pic of my crown moulding project, but
I am not having any luck sending a pic.
I took a picture with my digital camera, then downloaded it to "My
Pictures". W...
For those that may be interested, I recently helped with a crown
moulding project in one of my bathrooms. All corners were inside except
one, and that one corner happened to be round.
http://i...
I was at Lows a few days ago looking for some screws I could use for
framing. I have a tough time driving nails at different angles and like
to always have 3-4 inch screws handy. I couldn't find...
Can I stick ceramic (floor) tiles directly onto plywood or OSB? I'm a
little tight for clearance on a potential project (at least if I use 3/4"
for the subfloor, and I worry that anything less w...
I am a life long resident of the Pacific Northwest, but also reside, part
time, in the desert SW. In the PNW, stucco is rarely used because it gets
wet, remains wet and falls apart. Down here, i...
A friend's house (about 50 years old) has what I believe are original
Pella windows that need a bit of sash work. The balance mechanisms are
aluminum or zinc and have a round hump profile - flat on...