I need a handle puller for my 20 year old faucet. I have checked all
my catalogs and Googled quite a bit. I need something that will fit
below the "globe" and pull it straight up. 3 or 4 "fingers" ...
Our water comes from our well. When we built, we had sprinklers
installed...keeps the weeds healthy :)
There are two sprinkler zones. Each has sufficient outlets so that the well
pump runs c...
I'm thinking about buying a used electric air compressor for light use
around the house.
I've owned a compressor before, but I've never bought a used one
before. What should I watch out for, apar...
A while back I posted my problem with the dishwasher and received many
good tips. Thank you all. My wife especially wanted me to thank those
who suggested adding TSP to the new "imprived" dishwashin...
A while back I needed to cut some narrow lines in stucco and Googled for
diamond burrs. I found lots but this one...
http://www.lopacki.com/burrs/
had a large variety at *very* good prices (I...
I have a 1.5 story home,
http://www.dongardner.com/plan_details.aspx?pid=163
that has original paint from 2000. I'm pretty sure it's ready for
another as the caulking is cracking and the coverag...
XanaNews Statistic for alt.home.repair. 3/1/2011 6:20:45 AM
From article 420282 (2/1/2011 12:08:20 AM) to article 426985 (2/28/2011
11:58:49 PM)
Number of threads ................... 350
Num...
Did you ever notice that they never put flushing instructions on
toilets? How is someone supposed to know howto flush it?
Of course, anyone who has been there, knows that on the bottom of the
wo...
Everytime I replace a screen, a cat claws a hole in it. I thought the
whole thing was futile and I'd be replacing at least one screen every
week for the rest of my life. Then I saw an ad on the in...
Anyone know of a source for buying just the tips for a propane/MAPP
torch?
No sense buying a whole new TS4000 or other torch when all I need is
the new 'swirl' tip.
...
Wilfred Xavier Pickles wrote:
> This may well be hopeless.
>
> Years ago I built a woodworkers mallet from oak with some lead wool
> for mass. Worked fine for years, cracked a glue joint some ...
Has anyone hired a company to reface their kitchen/bathroom cabinets?
If so, were you happy with the results and can you give me some tips?
Many thanks.
Kate
...
A while back I posted asking for recommendations for security lights. I did
that because the reflectors on my Heath-Zenith lights were badly rusted and
I was thinking of replacing the lights rath...
I have a Delta single lever shower faucet that is about 15 years old.
Last time I changed a leaky valve and while removing the retainer
ring, I twisted the shower body a little. Fortunately it did n...