More tiling fun...
I've got a triangular-shaped channel that I need to fill before tiling
over - it's a strip of about 26" long and 2" wide, 1/4" deep along one
edge and 0" deep (relative to ...
Awl --
Purpose? Applications?
The minor diameter of the fine thread (under 2") appears to be about .115
(mebbe less, due to inadequate penetration of caliper edge), and .090 on the
coarse...
I have discovered a relatively obscure 4" scratch in my new laminate
flooring. Dang! Is there any was to obscure or remove this? Probably
not, but I thought I would ask.
Duke
...
I am finishing off the bathroom. I tiled all of the walls and the
floor. I am now ready to mount my shower curtain. I got the 'bow' type
that extends the curtain out over the edge of the tub, so it ...
I suppose my problem should have been expected, but it surprised me.
I have very plush rugs in my dining, living, and bed rooms. My has
come up with leg blood clots, and she requires a wheelchair t...
Hi,
We're in the final days of having our new house built with the first
walk through scheduled for later this week, but one thing I wasn't
sure about is the dishwasher and laminate flooring. Th...
I don't have a table saw.
Is it possible to rip down the row against the wall with a Jig Saw ?
--
Dell Inspiron
Pentium dual-core 2.2 GHz
2 GB DDR2 SDRAM
Windows Vista Home Premium SP1
---...
Hi,
I have a very small room on the first floor and the hot water radiator
takes way too much space. I'm not considering a baseboard.
Here's how I would like to heat it?
Place fin tubing be...
Has anyone bought from Lumber Liquidators ?
At HD Laminate floors run around $3.00 sf.
Lumber Liquidators show prices around $1.00
Or do you get what you pay for.
--
Dell Inspiron
Pentium du...
We've had slate or marble tile in entryways and front foyers
before, but I'm not that familiar with Travertine flooring.
Because of a health problem, carpet no longer works for us, and
neither d...
I now have the back and sides framed out. The woodriver bench plane is a bit
big for the job of the angles but made it work well enough sliver by sliver
until they all fit just right.
The top p...
I am having new ceramic tile installed on my shower/tub surround. The job
is being done well -- with cement backer board etc.
My question is about the 1/8-inch gap between the bottom of the cera...
As mentioned in another thread, I'm in the process of putting down 3/4
T&G in a few interconnected rooms/hall. I'm not in the kitchen yet but I
knew up front the dishwasher clearance may be a stro...