Why is one sump pump feeder pipe out of two plugged?
Is it because of stupidity**, or could there be a good reason?
A friend has lived in her house 2 years. It's about 50 or 60 years
old. It ...
Hi,
I have several heat ducts from my furnace in the basement which run
parallel and in between the floor joists. The basement is unheated but
maintains a temperature of about 55 degrees in the win...
-------------------------------------
I have a 20 year old basement floor which has been painted 3 times. The
room is heated with an in floor heating system. The water lines are approx
1" fro...
Little brick bungalow in a midwest US city, built in 1954. New Heil
80% furnace and AC in 03-06. Standard forced air ductwork.
For a long time now, I hear a heat-related noise. About 20-40 secon...
About two weeks ago we had a roto-rooter guy out as I've had to about once a
year to get rid of the tree roots that have grown into the drain under the
house + driveway. Three days later, the shower...
I have an Edison circuit with 12/3 wiring feeding a duplex outlet with
one circuit and associated outlet dedicated to a basement freezer. The
other outlet of the duplex pair is on the other leg and ...
I am moving my basement workshop to a new location. Currently it has
50 A sub-panel that I want to remove. How to do this, namely what to
do with the wire that goes from main panel to the sub-panel?...
The only window well our house has is the one that was constructed when
an existing lower-level window was enlarged so that it could function as
a basement egress window.
A couple of times the ...
was in my basement today because my laundry room is typically quite warm
in the winter despite not having a heat vent. Figured there had to be a
leaky duct joint somewhere, sure enough, I found i...
I'm going to be rewiring my entire 2 story 4 br house so how many
circuits do I need. From what I understand I need a dedicated circuit
for each of these:
1 dishwasher
1 microwave/hood
1 refrige...
I want to replace the hand rail that runs down our basement stairs.
The current one is just a 1.5" round stock and terminated back to the
wall with 45 degree miter cuts. Looks like the builder just ...
I am gutting and rebuilding my basement, in order to put in insulation and
thicker walls.
Question: Is it worth while cuttimg up all the old drywall into strips, and
screwing it up onto the sub...
We learn from our mistakes. That is why I am posting this. Learn from
mine.
I recently finsihed my basement. I built walls, installed drywall,
carpet, paint, etc.
After I did all this, one of ...
My house was built in the 1970s when apparently there was a huge
shortage of either lumber or smarts.
2x8 joists, 12" O.C.,14' span
1x3 X bracing in the center of the span
1/2" plywood subfloor ...
How do you do the wall? Just studs and drywall? What of moisture if any?
How about the floor, same thing? Studs and flooring?
I never did it before.
...