I tossed some laundry in the wash machine about an hour ago and it was
running normally. When it went into the spin cycle, the machine began
bouncing around and banging against the wall and floor. ...
My Kenmore series 90 electric dryer shuts off after few minutes using
normal cycle
or air dry only (without heat). No lints in the dryer or duct.I can
rotates motor
very easily without any noise. ...
I have a Frigidaire electric clothes dryer (Model GLER341AS0) that needed a
rear bearing assembly to be replaced. It was making a loud clunking noise
and a friend and I were able to determine tha...
I want to clean out the vent in my gas dryer. To really do that well,
I have to move it away from the wall.
To do _that_, sounds like I need to disconnect the gas line, and then
reconnect when d...
-------------------------------------
woods <
I would like to install a battery back up sump pump with a flow rate of
2000GPM.
It is illegal to drain a sump pump into the sewer, and my m...
http://abcnews.go.com/blogs/business/2011/10/how-to-build-a-made-in-america=
-home/
and the products used:
Product Manufacturer/Supplier State
Windows Amsco Windows UT
J bolts/foundation ...
I need to recaulk my tub. I think the caulk there now is all-purpose
polyseamseal, which has no silicone. Aside from using a tool to dig
the caulk out, is there anything I should do? Some web pag...
Greetings:
We have a finished basement with pine floors, one fairly small bedroom
down there and a main room. There's a laundry room down there too, as
well as a two piece bathroom (sink/toilet)....
I am putting a full bath in a basement level apartment. The basement has a
concrete floor, and center line of the horizontal 4-inch PVC sewer line that
runs out to the street is about 8 inches ab...
-------------------------------------
Took apart dryer...drum out...and we still cannot spin drum by hand. Have
cleaned all lint from all dryer parts...cleanest dryer in town! Shouldn\'t
...
This is a multi-part message in MIME format.
--------------080102000409030009060907
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
Content-Transfer-Encoding: 7bit
I am in the proces...
This is a multi-part message in MIME format.
------=_NextPart_000_0086_01CBD06C.C589D120
Content-Type: text/plain;
charset="iso-8859-1"
Content-Transfer-Encoding: quoted-printable
If you get...