Hello,
I have done gyprocking before and did do a wonderful job on my mothers
basement back in 1981 or so... A few things I can't remember or maybe it
wasn't invented back in the day.LOL ....
I need to replace drywall in my basement. I understand it comes in
regular, mold-resistant, and greenboard varieties, and I want to find
their relative prices. But I could not find that info via G...
I am running 1/2" copper lines in a crawl space to a double sink I am
installing... My question is this... Is there a "general height" at which
the 1/2" lines come out the wall....I am thinki...
The humidity in the crawl space is high during rainy season (winter) here,
and I want to set up a dehumidifier. This means I need to close the crawl
space vents temporarily. In the summer I won't ...
Would a GFCI outlet work as an overload breaker?
I have a refrigerator and chest freezer in my attached garage along with
the garage door opener and an outside outlet box. All are on one
circuit....
Sure, we are amateurs.
Sure, there are some areas that could be better.
Sure, it took almost 4 years to finish.
Sure we hired a contractor to do the drop ceiling. We know when we're
over our hrad....
You come home and notice smoke coming out of your house. When you grab
your doorknob, it burns your fingers. Because you dont have any hot
pads or welding gloves in your car, you have no way to op...
My son in law's house has a rough in for a bathtub/shower drain in the
floor in a hole filled with gravel, so don't know what's down there
yet, but he thinks he and I can install the tub drain. I d...
In finishing a basement how should electric outlets be spaced ( how far
apart )
--
Dell Inspiron
Pentium dual-core 2.2 GHz
2 GB DDR2 SDRAM
Windows Vista Home Premium SP1
--- news://fre...
I am putting a subpanel in the basement (Tigard, Oregon). There is
already a 6/3 copper cable run down there. This cable will be attached
to a breaker in the main panel. What is the maximum size bre...
The water pipes for my house are mostly attached to the ceiling of my
basement (which makes it super easy to get to!). It starts out 3/4", and
gets reduced to 1/2". My shower valve has 1/2 threads...
I'm interested in opinions of the merits of using copper versus cpvc (other
than cost). I recently had a cpvc pipe break inside the wall, and I'm in
the process of replacing all of the in-wall pip...
Almost finished excavating my crawl space. Down to 42" throughout.
The floor joists (some 6" some 8") are placed at irregular intervals. While
some are nearly 24" o.c., most of them are not. S...
Lately I've noticed a problem in my living room floor in that the wood
is buckling or crowning a bit with gaps between the boards directly
above where there is an HVAC duct running underneath betwee...
If I want a drainage system in my dirt crawl space, is french drain the only
choice? I believe they clog up after a number of years, perhaps between 10
to 20 years.
I need a non clogging draina...