I have a woodburning stove in my basement, and I'm getting tired of
dealing with the smoke and mess every time I try to light the thing and
it has a strong back draft (chimney is installed correct...
Last week, the power went out for the first time since I got my generator.
It took about 80 minutes to get it hooked up and running. I could have
done it in 5 minutes if not for some special problem...
Hi,
I'm rehabbing an old craftsman saw which has never been used but sat in
a garage for 20+ years. The tar paper had completely rusted into the
surfaces. I have cleaned it up substantially but...
I've recently been visited by several mice, and after taking all the
supplies out from under my kitchen sink, I noticed that that some of the
steel wool that had placed there 20 years ago has been...
Caesar Romano - 2009-11-27 11:37:00 [In: Appliances | ]
Hello all,
I need to convert a 50A 3-prong range receptacle to a 4-prong range
receptacle, so I need to run a 50' ground wire from the receptacle to
the ground buss. Can anyone tell me what size ...
I have an 8 year old MW that works fine. It has a rotating tray and
there is a plastic thing under that tray with 3 small wheels. Where
those wheels contact the bottom of the MW, the paint has wor...
We have a fairly new Roper fridge and we just finished tiling the
kitchen. While we were working on the kitchen we had rolled the
fridge in the dining room and had it running but no water hooked up...
We have De-Walt, Mastercraft, Bosch and Craftsman batteries; all
different. Most of the batteries or the associated chargers are
'shot'! And are incompatible with each other.
Just wondering if we...
I went to my local Sears Service & Repair Center today. I needed a
part for an appliance. Before I went I found the part at
http://www.searspartsdirect.com/. For a few seconds I hesitated.
Should ...
Hi Everyone,
My wife and I have decided to sell our older ranch style house to move
up to something newer and bigger since we now have a kiddo with
hopefully more to come. But with this we're de...
Awl --
Curious as to "fan logic".
I notice that in, say, kitchen hoods, central A/C air handlers, squirrel
cage blowers are almost always used.
btw, does "blower" imply the squirrel cage co...
I have a commercial natural gas stove that is acting weird. There are 6
burners and 2 of them will not light by themselves. I have to use a lighter
for them (pilot is on and the matching burners lig...
Hi folks, this is my first time to ask a question. I have a 5 year old
Amana natural gas stove. It worked perfectly on Thanksgiving. Today,
although the burners work, and the broiler works, the o...
The dryer is a Kenmore 110.86870100 made by Whirl pool.
The belt broke. In the process of disassembling the unit the belt idler
wheel bracket fell off.
I've looked at Repair Clinic and have the be...
Can anyone tell me the general draw of a squirrel cage fan in the plenum of
a heating/ cooling system in one or both speeds? I'm trying to decide if
this fan is cost effective (I'll do the math) ...