Hi,
I have just performed electrolytic derusting on cast iron (or steel?)
extensions for a craftsman table saw. The extensions are of this variety:
http://www.old-woodworking-tools.net/images/...
For some reaon, I bought a new countertop at HD or Lowes, in two
pieces (rather than order it precut).
I need some way to hold it in place while I glue the two main pieces
together. I thought I ...
Have a Craftsman gas push mower that I just bought at the beginning of
this summer. Suddenly the last two times I have used it it sounds like
it's going to stall although it never does. It hums alo...
I noticed that Milwaukee makes a compacted form of their sawzall which they
call the "Hatchet", with the handle being able to rotate in different angles
and takes up much less room then their norm...
I noticed Milwaukee makes a compacted version of the sawzall with a rotating
handle. My old sawzall just died and this one is intriging as I consider a
replacement.
http://www.amazon.com/Milwa...
I push the primer about 10 times, then pull the cord a few times. Nothing.
When I repeat (it's about 60 degrees here today), the mower runs strongly for
only 1 or 2 seconds. Then I have to repeat al...
I'm building a garage with some living space above it. I'd like to
insulate and cover the walls in the garage area as well. But I'd
rather use something besides wallboard since it is so easily dam...
I need to run a wire from a switch on the wall up the wall and across
the ceiling to a new overhead light. (Note that unfortunately, the
joists run perpendicular to the direction that I need to trav...
I want more lift and blower power on my lawn tractor lawn mower to blow
better into the grass catcher, picking up leaves. Can I twist the lawn
mower blades to give them more pitch? I can't seem to...
Hello,
I have a 2600 sq ft 4 level split home in Canada. It was built in
1985. This past spring we replaced our very non-effecient furnace with a
Tempstar 95% effecient gas furnace. It ...
The single handle kitchen faucet never had the hammer until the licensed
plumber replaced the washers to stop a leak. What would cause this to
suddenly become an annoying problem? The plumber is "...
I need to remove some 1/2" cement board - no tile yet - to do some work
inside the wall. The cement board is nailed on.
I'd like to save the cement board, saves buying and cutting. My first
t...
My snowblower tires are too soft. I try pumping them up with
my bicycle pump but they seem to stay at the same level. Are they
losing air around the rim? How can I get them to hold air?
Than...
I just built a pole barn (36 x 48). I put clear panels on one side 2
feet from the eave to allow light in during the daytime hours. This
seems to work great. I will use this mostly for storage of my...
I am in the stage of painting a spare room, which, on one wall, has an
access panel to service the bathroom tub plumbing. Currently, the panel area
contains basic door trim molding with a 1/8" thi...