I am going to be getting estimates and then signing a contract to have
3 rooms (game room, bedroom, storage room) in my basement,
drywalled,taped, and textured.
I would like to get some suggestio...
I wanted to put an outlet on the outside of my deck next to the pool
for the pump and timer. The deck is attached to the house. Can I run
UF cable from my basement under the deck, fastened to one of...
I would like to start using my basement more. I don't have the time or
money to finish it and not sure if I would want to anyway. Half the
wall is above ground so its insulated with plastic stapled...
Came into possession of an electronic air cleaner unit from a small
commercial building that was being gutted and renovated. Overall size
about 24 by 18 inches and appears to have been installed dir...
Daughter's 18 year old house air exchanger failed. It's in her
basement, hung from the main floor joists above. Found the single 115
volt one-twelfth HP motor that is mounted vertically and turns tw...
As mentioned in another thread, I'm in the process of putting down 3/4
T&G in a few interconnected rooms/hall. I'm not in the kitchen yet but I
knew up front the dishwasher clearance may be a stro...
Installing a 10K BTU A/C (8A) for a relative. The outlet to be used is on
the far end of a daisy chain of a half-dozen other outlets and two ceiling
lights.
It looks like I'll be running a ded...
I want to add a surface-mounted GFCI outlet on the wall in an unfinished
basement (for a washing machine). The wiring going to the outlet will be
12/2 NM.
I think I can figure out how to do it...
What are these plumbing things called?
Yea, I know they're a plug, but what's the actual name?
They're a rubber device with a bolt in the middle. When the nut is
tightened on the bolt, the rubbe...
I live in an area with a high water table, and my basement gets quite
humid; it recently flooded when the sump pump failed. The basement
area is about 1300 to 1500 sq ft, and is divided into rooms,...
Just bought an 1890 two-story brick house with a stone foundation.
The basement is dirt right now, and I'd like to pour a concrete slab
down there. There's sufficient cieling height for a 4" slab w...
In my basement, the main service panel is on one side of the house and they
had to run about 25 ft through the joists to tie the ground into a copper
water line. I need to add a couple of circuit...
As I'm getting closer to completing rewiring my 2nd floor, I'm thinking
that I would like to put cable, internet, phone, etc. in all the
bedrooms while I'm messing around... sounds like the easie...
In an earlier thread I stated I needed to add some circuits in the basement
and several replied that by code they need to be GFI. Several of the major
appliance manufacturers, including GE, Amana...
Ok, here's my situation. I am
installing a utility sink in the
basement. The house is all PEX, so
there should be no problem tapping into
the lines which are about 7' away. But,
today I w...