I'm going to be building some heavy duty shelves in the basement, attached
to concrete block. The horizontal supports will be 2x4s, with 5/8 material
for shelves.
My plan was to attach the 2x4s ...
I have a pressure tank in my garage which is, of course, connected to a tee
with the gauge and switch located very close to it. I would like to leave
the gauge & switch where they are but extend th...
I had gotten an Intex pool with a filter pump. I ran a UF cable
outside, and I installed a weatherproof outlet, plus I installed it
under my deck stairs so it would be out of the elements. The UF ca...
I started to clean up my basement and found some issues. There is a
place by my foundation that I can see light through and is filled with
spiderwebs. Its on my to do list to fill with some of the ...
I have to design a transition to flatten out some ductwork to go under
a support beam in my basement. This will bring this square section
down below the level of the drop ceiling. Where the drop se...
A few weeks ago I posted a question regarding getting rid of ceramic tiles.
Thanks to all who posted their answers. I appreciate it. I elected to use
a hilti and floor scraper.
Now my proble...
I have a problem with horizontal and step cracking in my concrete
block basement walls. The step cracking looks relatively minor, but
there is a nasty looking horizontal crack most of the length of ...
i have a wall that is about hip high that forms a 90 degree enclosing a
set of steps going down to the basement. i would like to widen( or cap )
the top with some wider lumber so that it may be us...
I started what I thought would be medium difficulty project and now on
stumped.
I wanted to install a ceiling fan in the master bedroom. There currently
are no ceiling lights, just a wall switch...
My wife and I are buying a new home and closing tomorrow. When the
hose bib that is installed in the garage is turned on (with no hose
attached) it sprays water onto the wall where the hose bib is,...
First of all, thanks to those that responded to my previous post.
I'm preparing my house for sale and two of my basement walls will
definitely need steel reinforcement beams and one will not.
...
Subject says all...
today I had my cable box lock up and when I rebooted it the picture was
all shaky and jaggy, so I took it back to the service center and traded
it in on a shiny new one. I ...
Alternate title-- This could only happen to me
A corner of the basement of this 1937 hovel is still the original 2
wire.
My ten cent circuit tester suggested electricity was flowing to the
ori...
I am finishing my basement. I used Tapcons to secure PT 2x4 to the
basement slab.
After a week of heavy rains, I noticed that all the screw holes were
weeping water. There was definite circles of...
After finding out I had termites I also found mold in my basement! A
section of my basement is above ground and insulated by the builder
with fiberglass and the vapor barrier on the inside of the b...