Follow-up on deck repair
The inspector came and left and left a message for me on the phone and
had no complaints about my deck. Even without the railing or the
steps.
So I"m off the hook fo...
I have Andersen double-hung windows. I finished the wood sash with
polyurethane 10 years ago. It is generally in fine shape except for
windows which experience a certain amount of condensation in ...
The fluorescent tubes in the laundry room fail to illuminate properly
and the diagnoses here is defective ballast.
I always thought that the "ballast" is part of the tube / bulb but
apparently it...
Due to back injury, I cannot lift items more than 50 lbs. So I'm looking for
a general purpose device to move heavy items around. E.g.
load a lawn mower into the trunk of a station wagon
move a ...
I'm starting to stain my house. It has T-111-like siding (mine is 4"
OC grooves). Before I got outside I'm staining new panels that will
replace some old ones.
The only thing I could figure out...
I have aluminum frame windows that frost up in the winter, thaw and discolor
the wood window sill.
Thinking that polyurethane would waterproof the sill, I sanded out the water
stain, restained ...
Hi! Need advice! I have a 35 yr old 2122sf split-level on clay soil on
the market for 120k, even though it's refurbished. We've had the
basement "finished" for many years, my dad put OSB board on th...
In a fully-insulated home in N. California SF Bay Area (very temperate
climes) is it common to seal the back side as well as the front of kickboard
molding? The owner is insisting that the back si...
I have an outside bench that needs refinishing. It is made from redwood
2x3s with 1x2 spacers between each 2x3 over brick pedsetals. Outer edges
are covered with 1x5s to hide anchoring to the pe...
They are pine on the inside.
From what I've read the process should go like this -
Lightly sand with 180 grit or finer sand paper.
Pella recommends applying a wood conditioner. Think Minwax...
I built a small cedar shed last fall out of cedar siding -- this stuff
if you care: http://www.potlatchcorp.com/files/Images/FSCWood/thumbs/potlatch061407_cedar_027_th.jpg
I was getting ready to p...
My deck needs to be re-stained.. I'm trying to decide whether or not
to re-stain it or just replace it. There are places on the deck that
have some "give" when I step on them. What is the best way...
This is a multi-part message in MIME format.
------=_NextPart_000_015F_01C9F93C.4D6294B0
Content-Type: text/plain;
charset="iso-8859-1"
Content-Transfer-Encoding: quoted-printable
It looks l...
My dad passed away in 1998. He loved power tools. Today I was going through the
attic and found an almost new Craftsman 315.276040 3 HP Electronic Plunge
Router. It was purchased new in 1992 for $21...
I'm working on a project to replace the bottom 20" of t1-11 type
siding on my house. I cut and stained new 20" sheets (including edge
staining). I cut off the bottom 20" of siding from the house. ...