Hi...
Our house was wired for cable when it was built in the 70's with old
rg59. On top of that, they horseshoe nailed the cable to the studs.
I started re-wiring it with rg6 but ran into a snag...
I currently need to get a bath painted and freshened that had the bath rugs
stuck to the floor. The backing has come off crumbly and remained on the
linoleum (sp?). I might believe the folks who h...
My office is in the 12x24 section of my 36x24 shop. All 36x24 is
insulated - walls and ceilings. The office side has 2 man doors - one
to the outside and the other to the shop. The shop-side has ...
Will be tiling shower walls and am considering using either an acylic
(Amertech) base or a solid surface base such as Swanstone. Any other
ideas, or opinions on these? Will not use tiles on floor th...
I have an old 1941 brick Cape Cod house that has never been insulated
properly. I've replaced the incredibly drafty multi-pane lead sash weight
windows with double-paned Andersens and have been gen...
I now have a new unfinished red oak hardwood floor installed in an apartment
that I will be renting out.
What I want is a truly *CLEAR* finish to put down on the new unfinished
flooring.
I h...
I started an earlier thread yesterday with the subject heading : "CLEAR
hardwood finishes? -- moisture cure, etc.".
I now have related question and I decided to post it as a separate topic in
a...
I had my floors redone about 5 years ago. The floors look in above average
condition. I'd like to apply another coat. There are a handful of areas I
need a little wood filler. Outside of adding s...
A friend of mine was doing some PVC work in his kitchen.
Slopped on the purple primer, and some dropped on the
hardwood floor.
His grand kids love the really kewl colors. But, SWMBO wants
the...
I've got an open, 3-stringer staircase leading to my basement. 12 stairs in
total. 2 x 10 treads. There are 2x4 walls right next to the staircase. I
used some ledger lock bolts to screw the ou...
Blogger's rant about one of the 2008 farm bill's provisions:
"Henceforth, all wood is to be a federally regulated, suspect substance.
Either raw wood, lumber, or anything made of wood, from table...
Hi,
I have a 3/4 pine over joints floor. A couple boards a loose. What's the
best way to secure them? A finishing screw? A brad nail? Construction
adhesive under the board (the ceiling downstai...
Hi,
The hardwood on the second floor bedroom above the kitchen is 3/4 pine
over bare joists. The ceiling in the kitchen is now open and I have a
chance to insulate for sound. I am aware of a nu...
I went to the http://Behr.com website to get more information about a Behr
polyurethane product I had just purchased at Home Depot. There was not
information on the http://Behr.com website about ...
Hi,
I live in an older home with top nailed 2"x5/16" red oak floors. I need
to replace a few boards. EXCEPT my boards are 2 1/16"!
Do I have a chance of finding boards like that somewhere? I h...