Hello,
I just had the furnace guy refire up my energy efficient furnace as
it went out last night. We have been having a cool spell (-45 to -50
Celciuse) in Canada here... I have a ...
I have a yard hydrant in my barn and it began dripping all the time
this past summer. In fall I replaced all the internal parts with a
repair kit, this includes the rubber stopper on the bottom of ...
I dance 3 or 4 nights a week on the Willowbrook Ballroom dance floor.
It is a 6200 square foot bare maple floor constructed in the early
1920's. It has had dancers on it continuously since then dan...
Recently I read somewhere that it's possible to add an auxiliary tank to
supply water heaters.
The purpose is, water comes from underground into a storage tank, where the
temperature of the wat...
I'd like to solicit information on how to best deal with a situation I
ran into today.
After getting a few detailed estimates and getting a recommendation
from a colleague who owns an apartment c...
Recently I read somewhere that it's possible to add an auxiliary tank to
supply water heaters.
The purpose is, water comes from underground into a storage tank, where the
temperature of the wat...
Recently I read somewhere that it's possible to add an auxiliary tank to
supply water heaters.
The purpose is, water comes from underground into a storage tank, where the
temperature of the wat...
We have a small greenhouse attached to the south side of our home.
It's 14' X 12' with a shed roof tapering from 10' on the house side to
6'. Roughly 1,400 cubic feet. It's a 2x4 frame with double-w...
rather than completely threadjack the ongoing thread about "best" CFLs...
I decided to take a systematic approach to attempting to find acceptable
CFL lighting for each room in my house. I have ...
Awl --
So apropos of the dialogue with the idiot Salty Dog on fraudulent hp ratings
in ahr, and after some links in the other rcm thread, I did another test.
Larry moe curly said:
They quit l...
I'm new here but wish I had found this site long ago.
I have designed and built an in floor hydronic heating system for a new
home I'm building in Ontario cottage country.
Because we are located wh...
Both the body of our high efficiency gas furnace and the ductwork seem
to be quite well-insulated since they are at best slightly warm to the
touch.
However, the sheet metal supply plenum coming ...
I noticed that our exposed sheet metal basement dryer duct gets quite
cold here in the frigid North -- acting like a "reverse" radiator when
the dryer is not in use.
Part of the problem may be du...
We have relatively new high efficiency gas furnaces that feed into 100
year old ductwork.
In particular, our 2 third floor bedrooms are fed off the same 9" riser
that feed the 2nd floor bedrooms ...