I now have a new unfinished red oak hardwood floor installed in an apartment
that I will be renting out.
What I want is a truly *CLEAR* finish to put down on the new unfinished
flooring.
I h...
I started an earlier thread yesterday with the subject heading : "CLEAR
hardwood finishes? -- moisture cure, etc.".
I now have related question and I decided to post it as a separate topic in
a...
I just built a playset out of pressure treated southern yellow pine. It
looks OK but I would like to put some redwood stain on it to make it look
nicer against the forest green slide and rockwall...
Recently, I made my wife an oak desk, which created alot of sawdust.
I used my shopvac to clean it up. I started to just throw the sawdust
away in the trash can, but I wanted to ask around if sawdu...
I went to an estate sale a couple of weekends ago and inquired about the
price of grandfather clock (GC). "$200" was the answer. I passed, but left
my card.
Last Monday I got a call saying seve...
I have a natural cedar deck that I pressure washed and then stained with
semi-solid this past spring. Came out quite nice.
A good portion of this deck in under a maple tree on one side and oak tre...
This single floor, plus full in ground basement, bungalow, has
ceilings of those one foot square fibrous interlocking tiles.
In family room and the adjoining kitchen and hallway (About one third
of...
I have a collection of good brushes (natural bristle) that I keep for
fine painting, such as varnishing. I just finished varnishing the new
woodwork in a room we remodeled, and spent a lot of tim...
Note that the bare area has some raised grain and that there is
considerable staining.
I propose:
(1) Strip
(2) Sand
(3) Refinish with stain/poly combo.
I assume I will need to appl...
Note that the bare area has some raised grain and that there is
considerable staining.
I propose:
(1) Strip
(2) Sand
(3) Refinish with stain/poly combo.
I assume I will need to appl...
SWMBO just bought a new table lamp for the desk in our computer room.
This lamp will be replacing one that uses two (2) 75 watt Incandescent
bulbs. This new lamp uses only one (1) bulb. The label ...
Hello. I have a leather top coffee table that needs to be
refinished. Is it possible to do it with out messing up the
leather? It seems to me the stripper, no matter how mild, would
still be ab...
I was making good progress on this- had applied two coats of oil stain
and the surface seemed dry. Water marks pretty much gone.
Maybe I didn't wait long enough (it was at least 12 hours) after
...
Hi,
I'm rehabbing an old craftsman saw which has never been used but sat in
a garage for 20+ years. The tar paper had completely rusted into the
surfaces. I have cleaned it up substantially but...