I have an ongoing project in my basement and was considering framing
out my HVAC ductwork. I was considering using furring hat channels
like this.
http://www.phillipsmfg.com/images/prod/mcif/chan/7...
I am in the process of ripping up old smelly carpeting from the
basement, which I figure to replace with ceramic tile. The basement
is an informal space but I would like it to be livable, i.e., les...
I am framing out an opening for a sliding closet door in my basement
and had a 2 questions:
1) The sliding door track kit says the height should be 1 3/4" more
than the door, which means 81 3/4...
Had a reputable sheet metal company come to my house to give me an estimate
for replacing the main FHA trunk to a smaller height to gain some headroom
in my basement. The trunk is about 40 feet l...
I need to move a steam radiator about six feet from its current
location. This is a single pipe system with black pipe. The piping is
all accessible in the basement.
I have zero experience workin...
Floor insulation ==> frozen pipes???
I'm eligible for a low-income weatherization program.
They want to put insulation in my floors.
It's a ranch-style frame house 40 years old.
Crawl space i...
In my basement I am renovating one of my rooms that has a 30" door.
There is no jamb, the hinges are screwed directly into the 2X3
framing, and the walls were 70's style wood paneling that were nail...
I want to add a utility tub next to the washer in the laundry room.
The room is on the first floor with basement access. The washer is
connected to a utility box that supplies hot/cold water and dra...
Is it safe to buy a home with Cinder Block basement walls instead of Poured
Concrete ?
--
Dell Inspiron
Pentium dual-core 2.2 GHz
2 GB DDR2 SDRAM
Windows Vista Home Premium SP1
...
I have a property that has an outdoor concrete stairway that leads to a
basement entrance. The steps run down below grade along the back wall of
the basement to a landing, and then by turning rig...
FOLLOW-up on deck. Over the last couple years I asked questions here
about building a deck that could be partially disassembled (to build
something undderneat) and I've thought and maybe posted a...
I push the primer about 10 times, then pull the cord a few times. Nothing.
When I repeat (it's about 60 degrees here today), the mower runs strongly for
only 1 or 2 seconds. Then I have to repeat al...
I need to run a wire from a switch on the wall up the wall and across
the ceiling to a new overhead light. (Note that unfortunately, the
joists run perpendicular to the direction that I need to trav...
I've been designing and working on this for over a year and have a home
that facilitates experimentation fairly easy.
The system design so far: 4 Ton RUUD Air Handler factory equipped with
R-410...
I've had a GFCI outlet that powers a refrigerator and some kitchen and
basement outlets trip twice within the last year. I've reset it after each
trip and it seems to go another six months before i...